Every LED light on your Netgear WiFi router has a meaning. If the LED on your device is blinking green, it means everything is in place. In case the LED is flashing orange, it means your device is witnessing some connectivity issues. But, by any chance, the LED is blinking red, your internet experience is about to go downhill.
But, worry not because following the below-mentioned troubleshooting hacks will surely help you resolve the router red light issue. Thus, scroll down, and read on.
Fixed: Netgear Router Red Light Issue
- Reboot Your Netgear Router
We all are well aware of the power that technical glitches hold. They are capable of ruining the performance of any device that comes their way. Chances are that you are facing the Netgear router red light issue because of these annoying glitches.
To bid adieu to them, reboot your router by following the steps given below:
- Power off your Netgear router and unplug it from its electrical socket.
- Wait for some time.
- Plug your home router back into its electrical outlet and turn it on.
Once you are done rebooting your Netgear router, check whether the red light issue persists. If it does, follow the next troubleshooting hack.
- Check the Ethernet Connection
For a secure internet connection, the Ethernet cable connecting your Netgear WiFi router and the existing modem should not be worn out or damaged.
On the off chance, it is, we recommend that you either get your Ethernet cable replaced with a new one or connect your devices using a wireless source.
- Pull Your WiFi Devices Closer
If the distance between your Netgear WiFi router and the existing modem is too much, it can get difficult for them to transmit signals properly and lead you to further technical issues in the future like routerlogin.net not working, etc. Therefore, make sure that your wireless devices are placed in close proximity.
- Call Your ISP
Chances are that your Internet Service Provider is not doing his job properly due to which you are struggling with the Netgear router red light issue.
To confirm the same, contact your ISP. Does he agree that the issue is from his end? If yes, then give him a strict deadline to get it resolved.
- Perform Netgear Firmware Update
Updating the firmware of your Netgear wireless router to the latest version can also help you stop the LED on your device from blinking red.
Thus, walk through the guidelines outlined below and get to know the process to perform Netgear router firmware update:
- Switch on your computer.
- Open an internet browser.
- In the address field of the internet browser, type 192.168.1.1.
- Press the Enter key.
- You will come across the Netgear router login page.
- When prompted, fill in the admin username and password and click Log In.
- Once you are on the Netgear Genie dashboard, navigate to Settings.
- Under Maintenance, select Firmware Update.
- Follow the on-screen prompts.
With that, you will be able to perform Netgear router firmware update with ease.
- Reset Your Netgear Router
Did none of the troubleshooting hacks mentioned above help you get rid of the Netgear router red light issue? Well, in that case, you need to opt for the last resort i.e. to perform factory default reset.
Take the help of the following troubleshooting hacks to reset your device:
- Locate the Reset hole on your home router.
- Get an oil pin and carefully insert it into the Reset hole.
- Hold on for a few seconds.
Once you are done resetting your Netgear wireless router, install it from scratch by accessing the Netgear Genie smart setup wizard.
Wrapping Up
Our article on troubleshooting the Netgear router red light issue has concluded here. Let us hope that after walking through the tips mentioned above, you will be able to get rid of the red light issue in a matter of minutes.
If you are aware of any other hack through which this issue can be resolved, do share it with your fellow readers via the comment section.
